Fault finder: Crop water stress from leaf temperature

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reading looks wrong: what should I check?

Check the sensor sees only leaves and is not in shade.

Values jump: what should I check?

Wind and passing clouds change it; average more readings.

Device not found: what should I check?

Check I2C addresses and the 5 V module version.

OLED blank: what should I check?

Check its address 0x3C.