Fault finder: Seedling height tracker
9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No readings: what should I check?
Sensor not found. Check the I2C wiring and address.
Heights jump around: what should I check?
The sensor sees leaves and the pot rim differently. Aim at the stem tip and average more.
No file: what should I check?
SD card not FAT32 or wrong CS pin.
Wrong date: what should I check?
The RTC lost its time. Re-upload to set it.
