Fault finder: PIR vs microwave vs radar comparison
10 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.
0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10
ESP32 supply pin
Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.
You should see: 3.15 to 3.45 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
A sensor never triggers: what should I check?
Check its power (5 V) and the signal pin.
Everything triggers all the time: what should I check?
Move the sensors apart and away from the fan or router.
OLED blank: what should I check?
Check the I2C address.
