Fault finder: Pico W fridge temperature watch

7 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No DS18B20 found: what should I check?

Check the 4.7 kilo-ohm resistor between data and 3V3 and the three wires.

Reads 85.0 or -127: what should I check?

Check the power wire and the pull-up resistor.

Page does not open: what should I check?

Check the address from the shell and that the phone is on the same Wi-Fi.

Wi-Fi does not connect: what should I check?

Check the name and password, and that the network is 2.4 GHz.

Door does not seal: what should I check?

Use a thin, flat part of the cable and check the seal after fitting.