Fault finder: Pico touch dimmer lamp

7 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LED does not light: what should I check?

Check the LED direction, the long leg goes to the resistor.

Skips levels: what should I check?

A tap is read twice, raise the 40 millisecond pause.

Changes by itself: what should I check?

Keep your hand and wires away from the pad, and keep the module on a stable surface.

Brightness steps look uneven: what should I check?

Change the numbers in the LEVELS list.

Pad does nothing: what should I check?

Check the I/O wire is on GP15 and the module has 3.3 V.