Fault finder: Pico knob-controlled servo

9 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Servo twitches or the Pico resets: what should I check?

Power the servo from its own 5 V supply and join the grounds.

Servo does not move: what should I check?

Check GP16 and the signal wire colour.

Servo hums at the ends: what should I check?

Reduce MIN_US and MAX_US slightly.

Jittery movement: what should I check?

Add a 100 nanofarad capacitor from GP26 to GND.

Program does not start on power-up: what should I check?

Save it on the Pico as main.py.