Fault finder: Pico N20 motor speed knob

7 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Motor does not turn: what should I check?

Check the transistor pins (base, collector, emitter) against its datasheet.

Motor only hums at low speed: what should I check?

Normal, the program skips the lowest duty.

Pico resets when the motor starts: what should I check?

Use a better USB port or cable, or power the motor from a separate supply with a common ground.

Transistor gets hot: what should I check?

Make sure it is fully switched on and the motor is not stalled.

Speed jumps around: what should I check?

Check the knob wiring and keep wires short.