Fault finder: Raspberry Pi Pico first steps in MicroPython
9 checks for this build on the Pico. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Pico supply pin
Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.
You should see: 3.15 to 3.45 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Thonny cannot find the Pico: what should I check?
Use a data cable, and select the Pico's port at the bottom right of Thonny.
LED never lights: what should I check?
Check its long leg goes to the resistor side, and that you used GP15 (physical pin 20).
One press counts twice: what should I check?
Raise the 200 ms debounce to 300.
