Fault finder: Pico dusk night light

9 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LED never lights: what should I check?

Check polarity, GP15 and the resistor.

LED always on: what should I check?

Run it with the room light on, or swap the divider parts.

Flickers: what should I check?

Widen the gap between ON_BELOW and OFF_ABOVE.

No reaction to light: what should I check?

Check the divider wiper goes to GP27.

Program does not start on power-up: what should I check?

Save it on the Pico as main.py.