Fault finder: Pico temperature logger with a probe

11 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No probe found: what should I check?

Check the yellow wire on GP15 and the 4.7 kilo-ohm pull-up.

Reads 85 degrees: what should I check?

The probe has just powered up, wait for the next reading.

ImportError for ssd1306: what should I check?

Install the micropython-ssd1306 package.

Blank screen: what should I check?

Check the OLED address 0x3C and the GP0 and GP1 wires.

Program does not start on power-up: what should I check?

Save it on the Pico as main.py.