Fault finder: Pico precision NTC thermometer

9 checks for this build on the Pico. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Pico supply pin

Plug the Pico into USB. Black probe on a GND pin, red probe on the 3V3(OUT) pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reads nonsense: what should I check?

Check the divider is wired with the thermistor on the ground side.

OSError on the converter: what should I check?

Check the address 0x48 and the I2C wires.

Reads high or low by a few degrees: what should I check?

Check the fixed resistor value, and the thermistor's beta number.

Reading jumps: what should I check?

Keep the wires short and the thermistor still.

Display blank: what should I check?

Check the OLED address 0x3C.