Fault finder: Pi probe temperature log to a file

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No 28 folder: what should I check?

Check the one-wire interface is on and the pull-up is fitted.

Reads 85 degrees: what should I check?

The probe has just powered up, wait for the next reading.

File not found: what should I check?

Change the LOG path to your home folder.

Permission error: what should I check?

Run as your own user and check the folder exists.

No lines written: what should I check?

Look for the checksum YES in the device file.