Fault finder: Time-lapse camera
7 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No camera found: what should I check?
Check the ribbon and that the camera is enabled.
Colour flickers: what should I check?
Fix white balance and exposure.
Photos stop: what should I check?
Check the card is not full and the power is steady.
