Fault finder: Pet water bowl reminder

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Light flashes with a full bowl: what should I check?

Change WET_IS_HIGH to false.

Never notices the water level: what should I check?

Press the sensor flat against the wall and move it to the mark.

False alarms: what should I check?

Increase LOW_CONFIRM_MS.

No beep: what should I check?

Wait a full hour, or shorten BEEP_AFTER_MS to test.

LED stays dark: what should I check?

Check its direction and the 220 ohm resistor.