Fault finder: Parts drawer finder
6 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.
0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6
ESP32 supply pin
Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.
You should see: 3.15 to 3.45 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Page will not load: what should I check?
Check the Wi-Fi details and the IP address.
Wrong drawer lights: what should I check?
Check the strip direction and the numbering.
Flicker: what should I check?
Add the capacitor and the data resistor.
Colours wrong: what should I check?
Change GRB to RGB in the sketch.
