Fault finder: Overvoltage crowbar protection

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Never fires: what should I check?

Use a smaller gate resistor or a slightly larger Zener.

Fires at normal voltage: what should I check?

Check the Zener value and polarity.

Fuse never trips: what should I check?

The supply is too weak; raise its current limit.