Fault finder: Oscilloscope first steps

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Waveform runs: what should I check?

Set the trigger source, edge and level.

Signal looks tiny or huge: what should I check?

Change volts per division and check the 10x setting.

Noisy trace: what should I check?

Check the ground clip is connected and short.

Square wave overshoots: what should I check?

Compensate the probe with the calibration screw.