Fault finder: Optocoupler isolation lab

9 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LED never lights: what should I check?

Check the PC817 orientation and that the input LED side has current.

LED always on: what should I check?

The output side is wired to the input battery. Keep them separate.

Very dim: what should I check?

Output transistor is saturated or the LED is wrong way round.

CTR is out of range: what should I check?

The transistor may saturate at high current. Use a larger output resistor.