Fault finder: Open-collector wired AND

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Both always read 0: what should I check?

Check the pull-up resistor goes to 5V and not GND.

Neither responds to the magnet: what should I check?

Turn the magnet round or try the other face.

Sensor gets warm: what should I check?

Disconnect, the power pins may be swapped.

Joined wire stays low: what should I check?

A magnet may be left near one of the sensors.

No serial text: what should I check?

Set 9600 baud.