Fault finder: Op-amp inverting amplifier lab

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Output stuck at a rail: what should I check?

The feedback is open or pin 3 is not grounded.

Gain is lower than predicted: what should I check?

Resistors are 5 % tolerance. Measure each one.

Output offset with zero input: what should I check?

Op-amp input offset. Small errors are normal.

Output oscillates: what should I check?

Add the 100 nF supply capacitors close to the chip and keep leads short.