Fault finder: Active low-pass and high-pass filters

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No output: what should I check?

Check the +V and -V supply on pins 8 and 4 and the pin 3 connection.

Output clips: what should I check?

Reduce the input amplitude.

Cut-off is wrong: what should I check?

Check the capacitor values and the parallel pair.

Noise: what should I check?

Add the 100 nF capacitors close to the chip and keep input leads short.