Projects / 1-Wire sensor bus / Fault finder

Fault finder: 1-Wire sensor bus

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Count is zero: what should I check?

Check the 4.7 kΩ pull-up between D2 and 5V.

Reads -127: what should I check?

Sensor lost power or the data wire is loose.

Reads 85: what should I check?

The sensor did not finish converting. Check power and wait before reading.

Sensor gets very hot: what should I check?

It was wired backwards. Disconnect, let it cool and check the pinout.