Fault finder: Four-digit clock with TM1637

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Display shows 8888: what should I check?

The clock chip is not found, check the I2C wires.

Time resets each power cycle: what should I check?

Fit the backup cell in the clock module.

Colon does not blink: what should I check?

Check showNumberDecEx colon mask for your display.

Time a few seconds off: what should I check?

Set the minutes to reset the seconds.

Display too dim: what should I check?

Raise the value in setBrightness.