Fault finder: Negative supply from a single rail

6 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Output near 0 V: what should I check?

Check pin 3 is on ground and pin 8 on 5 V, and chip orientation.

Positive voltage out: what should I check?

Reservoir capacitor is the wrong way round. Swap it.

Chip gets hot: what should I check?

Output is overloaded or a capacitor is reversed. Disconnect and check.

Output very noisy: what should I check?

Add a 100 nF capacitor across the supply pins.