Fault finder: Analog multiplexer data selector
9 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
All channels read the same: what should I check?
Check the address lines and the inhibit pin.
Readings are noisy: what should I check?
Add a 100 nF capacitor on COM to ground.
Channel numbers wrong: what should I check?
Check the pin order against the datasheet.
Signal clipped: what should I check?
Keep inputs between 0 and 5 V.
