Fault finder: Ten multimeter measurements

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Meter shows 0 for current: what should I check?

The fuse may be blown, or the lead is in the wrong jack.

Resistance reads too low: what should I check?

The part is still in the circuit or in parallel with another.

Voltage reading is zero: what should I check?

Check the red lead is back in the voltage jack.

OL on resistance: what should I check?

The part is open or the range is too low.

Diode reads OL both ways: what should I check?

Swap the leads to find the direction.