Fault finder: Multimeter diode test lab

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

OL both ways: what should I check?

The part may be open, or an LED needs more voltage than the meter gives.

Reads zero both ways: what should I check?

The part is shorted or you are on the buzzer position, so check the dial.

Readings jump: what should I check?

Hold the probes steady on clean leads.

Meter shows nothing: what should I check?

Check the battery and the probe sockets.

LED does not glow: what should I check?

Some meters cannot light it, so try the other direction and a dim room.