Fault finder: Four sensors on one I²C bus

12 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 12 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 12

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Scanner finds nothing: what should I check?

SDA and SCL swapped, or no common ground.

Two modules, one address: what should I check?

Change one with its address pin, for example BME280 SDO to 3V3 for 0x77.

Bus hangs with all four: what should I check?

Too many pull-ups in parallel; remove some on the modules or shorten wires.