Fault finder: Motor start-stop with relays

5 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Relay drops when START is released: what should I check?

The hold-in contact is not wired across START.

Relay does not click: what should I check?

Check the coil voltage and the stop button type.

Motor does not run: what should I check?

Check contact set 2 wiring and the supply.

Relay buzzes: what should I check?

Voltage is too low. Use a proper 12 V adapter.