Fault finder: Morse beacon with keying circuit

5 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Buzzer plays a steady tone: what should I check?

A passive buzzer needs tone(), check D9 and that noTone is called.

No keying on the optocoupler: what should I check?

Check the LED side polarity and the 330 Ω resistor.

Letters run together: what should I check?

Check the 2-dot delay after each letter.

Radio never keys: what should I check?

Check the key jack polarity and that the radio uses a simple closing-to-ground key line.