Projects / Model drawbridge / Fault finder

Fault finder: Model drawbridge

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Servo twitches or the Nano resets: what should I check?

The deck is too heavy, use a lighter one.

Deck goes the wrong way: what should I check?

Swap UP_ANGLE and DOWN_ANGLE.

No bell: what should I check?

Check you have a passive buzzer on D8.

LED stays dark: what should I check?

Check its direction and the 220 ohm resistor.

Nothing happens on a press: what should I check?

Check the button is wired to D2 and GND.