Fault finder: USB MIDI drum pad controller
7 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No device appears: what should I check?
You need a board with native USB, such as the Leonardo.
Double triggers: what should I check?
Raise the lockout time or threshold.
Pads always on: what should I check?
The zener or resistor is missing, or the threshold is too low.
Crosstalk between pads: what should I check?
Isolate the pads with foam and raise the threshold.
