Fault finder: RFID memory card game

8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No card read: what should I check?

Hold it flat and closer to the reader.

Wrong matches: what should I check?

Use the full UID, not one byte.

No sound: what should I check?

Check the file names and the RX resistor.

Reader fails after a while: what should I check?

Check the 3.3 V supply.