Fault finder: Eight-digit event counter

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Display blank: what should I check?

Check power, DIN, CLK and CS wires and the shutdown call.

Digits in reverse order: what should I check?

Change the position order in showCount.

Counts jump by two: what should I check?

Increase the debounce delay.

Number resets after power cut: what should I check?

Wait five seconds after the last count before power off.

Dim display: what should I check?

Raise the setIntensity value.