Fault finder: Logic probe with three LEDs

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always yellow: what should I check?

The probe is not reaching a driven pin, or the ground clip is not joined.

Red and green flicker when touching 5V: what should I check?

Check for a loose probe connection.

Open probe shows green or red: what should I check?

One divider resistor is the wrong value or missing.

3.3 V high shows yellow: what should I check?

Check the supply is really 3.3 V and lower HIGH_MIN a little.

Slow pulses seem steady: what should I check?

Increase the 60 ms watch window to catch slower signals.