Projects / Line follower robot / Fault finder

Fault finder: Line follower robot

7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

A wheel turns the wrong way: what should I check?

Swap that motor's two wires at the L298N outputs.

The robot spins in circles: what should I check?

The sensor logic is inverted. Change BLACK to LOW, or adjust the sensor trimmers.

Motors hum but do not move: what should I check?

Raise SPEED, check the ENA/ENB jumpers are removed and the wires go to D5/D6, and charge the cells.

The Uno resets when the motors start: what should I check?

The cells are weak or the wiring is thin. Use good cells and a direct, short ground wire.