Projects / LED resistor lab / Fault finder

Fault finder: LED resistor lab

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LED does not light: what should I check?

Reversed. The long leg is the anode and goes towards the resistor.

LED burns out: what should I check?

No resistor or too small a resistor. Always calculate first.

Meter shows 0 mA: what should I check?

The meter is in the wrong socket or the circuit is open.

Forward voltage reads high: what should I check?

The meter is measuring in a different range. Use the 20 V range.