Fault finder: Two-transistor LED flasher
8 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Both LEDs stay lit: what should I check?
The circuit locked up. Touch a base with a finger or power it again.
Does not oscillate: what should I check?
The capacitor polarity is wrong, or a transistor is damaged.
Very fast, appears steady: what should I check?
The capacitors are too small. Use 10 µF or more.
One LED never lights: what should I check?
Check its direction and the collector resistor.
