Fault finder: LED chaser with 555 and 4017

10 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No LEDs: what should I check?

Check the 4017 power pins 16 and 8 and the 555 output.

Two LEDs lit: what should I check?

Check the reset pin is not floating.

Chase does not move: what should I check?

Check clock enable pin 13 goes to ground.

Dim LEDs: what should I check?

Normal at these resistor values; use transistors for bright ones.