Fault finder: LDR versus lux sensor comparison lab

7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

BH1750 reads 0: what should I check?

Check the I2C wiring and address.

ADC saturates: what should I check?

The room is too bright for the 10 kΩ resistor. Try a different value.

Fit is poor: what should I check?

Use more points and keep the lamp type the same.

Readings jump: what should I check?

Keep other light sources constant.