Fault finder: LDR response curve lab

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Vout never changes: what should I check?

Check the LDR is in the divider and the meter is across the fixed resistor.

Readings jump about: what should I check?

Mains lights flicker, try daylight or a steady torch.

Numbers differ a lot from these: what should I check?

LDRs vary widely, so use your own curve.

Resistance works out negative: what should I check?

You have swapped Vout, so read across the fixed resistor.

LDR slow to settle: what should I check?

Wait a few seconds after changing the light.