Fault finder: Knight Rider LED scanner
9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
One LED never lights: what should I check?
It is the wrong way round or its resistor is not in the row. Flip it and check the wire to its pin.
No fading, LEDs just blink: what should I check?
A delay() was added to the loop, which slows the software PWM. Remove it.
The tail flickers: what should I check?
The loop is too slow. Avoid Serial printing inside loop.
Speed does not change: what should I check?
Check the pot's middle pin goes to A0 and the outer pins to 5V and GND.
