Fault finder: Keypad password door lock
8 checks for this build on the Uno. Work from the top: power first, then each part, then the code.
0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8
Uno supply pin
Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Wrong keys appear: what should I check?
Rows and columns swapped, or the ribbon is reversed. Swap the rows[] and cols[] arrays.
The Uno resets when the lock opens: what should I check?
The flyback diode is missing or reversed. Its stripe must face the solenoid plus.
The solenoid gets hot: what should I check?
It is made for short pulses. Keep the open time to a few seconds.
Safety: what should I check?
A fail-secure solenoid stays locked if power fails. Keep a mechanical key or exit button for real doors.
