Fault finder: Shop shelf stock monitor

5 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Counts jump: what should I check?

Keep the tray still and use bars that are firmly mounted.

Negative or zero: what should I check?

Check the wire colours and that the load is in the arrow direction.

Wrong count: what should I check?

Re-weigh a single item and reset u.

Page not found: what should I check?

Check the IP address on the Serial Monitor.