Fault finder: Two-room wired intercom

6 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No sound: what should I check?

Check the bias on the microphone.

Squeal: what should I check?

Lower gain or move apart.

Hum: what should I check?

Earth the shield at one end only.

Weak sound: what should I check?

Use a shorter cable or a larger supply.