Projects / Insect trap counter / Fault finder

Fault finder: Insect trap counter

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Counts by itself: what should I check?

Shade the sensor from the lamp and from sun, and turn down its sensitivity.

Never counts: what should I check?

Check OUT on D2 and turn up the sensitivity screw.

Red light on: what should I check?

Check the card is FAT32 and wired to D10 to D13.

Wrong hour: what should I check?

Set the clock again, or re-upload.

File is empty: what should I check?

Wait for the hour to change, then remove the card.