Fault finder: Inductor back-EMF lab

9 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LED never flashes: what should I check?

Try a bright red LED and a dim room, or check it is reversed relative to the supply.

LED stays lit while pressed: what should I check?

It is the wrong way round. Reverse it.

Relay will not click: what should I check?

Use fresh batteries and check the coil terminals.

Diode makes the relay buzz: what should I check?

It is the wrong way round. The band goes to the supply side.