Fault finder: Low-power 555 blinker
8 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No flashes: what should I check?
Check pin 1 and pin 8 power and that the LED is the right way round.
LED stays on: what should I check?
Pin 6 is not joined to pin 2 or the capacitor is not connected.
Very faint flash: what should I check?
Use a high-brightness LED or lengthen the flash with a larger RB.
Flashes too fast: what should I check?
Check RA is 100 kilohm and the capacitor is 10 microfarad.
Meter reads zero: what should I check?
Check the red lead is in the mA jack.
