Fault finder: Hallway motion chime

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Chimes by itself: what should I check?

The radar sees through the wall, so turn it or put foil behind it.

Never detects: what should I check?

Check VIN has 5 V and OUT goes to D2, and wait 30 seconds after power-up.

Buzzer is too quiet: what should I check?

Make sure it is a passive buzzer on D8 and try a 220 ohm resistor.

Chime plays twice: what should I check?

Your hand moved in and out, so raise LOCKOUT.

Mute button does nothing: what should I check?

Check it goes to D3 and GND and is pressed across its legs.