Fault finder: Garden hose water usage meter

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing counts: what should I check?

Check the yellow wire is on D2 and the arrow matches the flow.

Reading is wrong by a fixed percent: what should I check?

Calibrate with a bucket.

LCD blank: what should I check?

Try address 0x3F, or turn the contrast screw.

Count jumps when the pump starts: what should I check?

Move the sensor wire away from the pump motor.

Leaks at the sensor: what should I check?

Use thread tape on the adapters and do not overtighten the plastic.